SYNTHESIS OF 3-HEXYLACRYLIC ACID (Non-2-enoic acid)
- Dissolve 57g (0.55 mol) of malonic acid in 92.5 ml of dry
pyridine contained in a 500-ml round-bottomed flask, cool the solution in ice
and add 57g (70 ml, 0.5 mol) of freshly distilled heptanal with stirring or
vigorous shaking.
- After a part of the aldehyde has been added, the mixture
yields a semi-solid slurry of crystals.
- Insert a calcium chloride tube into the
mouth of the flask and allow the mixture to stand at room temperature for 60
hours with periodic shaking.
- Finally, warm the mixture on a water bath until
the evolution of carbon dioxide ceases (about 8 hours) and then pour into an
equal volume of water.
- Separate the oily layer and shake it with 150 ml of 25
per cent hydrochloric acid to remove pyridine.
- Dissolve the product in benzene,
wash with water, dry with anhydrous sodium sulphate and distil under reduced
pressure. Collect the nonenoic acid at 130-132 °C/2mmHg. The yield is 62g (79%).
Cognate preparations: Crotonic acid [(E)-But-2-enoic
acid]
- Mix together in a 250-ml flask carrying a reflux condenser and a calcium
chloride drying tube 25g (32 ml, 0.57 mol) of freshly distilled acetaldehyde
with a solution of 59.5g (0.57 mol) of dry, powdered malonic acid in 67g
(68.5 ml, 0.85 mol) of dry pyridine to which 0.5 ml of piperidine has been
added.
- Leave in an ice chest or refrigerator for 24 hours.
- Warm the mixture on a steam bath
until the evolution of carbon dioxide ceases.
- Cool in ice, add 60 ml of 1:1
sulphuric acid (by volume) and leave in the ice bath for 3-4 hours.
- Collect the
crude crotonic acid (c. 27g) which has separated by suction filtration.
- Extract the mother-liquor with three 25 ml portions of ether, dry the ethereal
extract, and evaporate the ether; the residual crude acid weighs 6g.
- Recrystallise from light petroleum, b.p. 60-80 °C; the yield of crude crotonic
acid, m.p. 72 °C, is 20g (41%).
Sorbic acid (Hexa-2,4-dienoic acid):
- Place 40g (46.5 ml,
0.57 mol) of croton-aldehyde (b.p. 101-103 °C), 60g (0.575 mol) of malonic
acid and 60g (61 ml, 0.76 mol) of dry pyridine (b.p. 113-115 °C) in a 500-ml
round-bottomed flask, attach a reflux condenser and heat on a water bath for 3
hours.
- At the end of this period the vigorous evolution of carbon dioxide will
have ceased.
- Cool the mixture in ice and cautiously acidify it by the addition
of a solution of 21.3 ml of concentrated sulphuric acid in 50 ml of water with
shaking.
- Most of the sorbic acid separates out immediately; a more complete
separation is obtained by cooling the solution in ice for 3-4 hours.
- Filter the
acid at the pump and wash it with a little ice-cold water.
- Recrystallise from
about 125 ml of boiling water; the maximum recovery of purified acid is achieved
by leaving the solution in an ice chest or a refrigerator overnight
and then filtering.The yield of sorbic acid, m.p. 134°C, is 20g (31%).
No comments:
Post a Comment
We specialize in producing high value chemicals. Besides our regular products, we strive to develop new products based on customer’s requirements. Our R&D center plays crucial role in handling complex chemistries and developing newer technologies. We respect intellectual property rights and have confidentiality agreement with various multi national companies. We undertake contract manufacturing of fine chemicals and advance intermediates of API’s.